For the safety of belt conveyors, I hope to help! Check Valve,Non Return Valve,Swing Check Valve,Double Check Valve LIANGGONG VALVE GROUP CO.,LTD , https://www.lgvalvegroup.com
Conveyor safety hazards:
1. When the belt is slipping, the belt must not be pulled by hand to avoid accidents.
2. The conveyor should start at no load. Wait until the operation is normal before feeding. It is strictly forbidden to start the machine after feeding.
3. Before stopping the machine, the material must be stopped first, and the material on the belt can be stopped before being discharged.
4. Before using the conveyor, check whether the running parts, the tape buckle and the carrying device are normal, and whether the protective equipment is complete. Whether the tension of the tape is appropriate.
5. The temperature of the material to be delivered shall not be higher than 50 °C and lower than -10 °C.
6. The fixed conveyor should be installed on a fixed basis according to the specified installation method. The wheel should be wedged with a triangular wood or braked with a brake before the mobile conveyor is officially operated. In order to avoid walking in the work, when there are multiple conveyors working in parallel, there should be one meter between the machine and the machine.
7. When the tape runs out during operation, it should be stopped and adjusted, and should not be used barely to avoid wearing edges and increasing load.
8, transport electromechanical "target=_blank> machine motor must be well insulated. Mobile conveyor electromechanical "target=_blank> machine cable do not pull and drag. The motor must be reliably grounded.
9. When several conveyors are operated in series, they should start from the discharge end and start in sequence. The material can only be transported after it has been in normal operation.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn