Expert strokes to install the correct face (hand) basin

>>> Links: How to waterproof the bathroom?

Installing a washbasin is not easy, and the following points must be observed when installing:
1) Before installation, check whether the basin body and the water inlet are flat.
2) When installing a short drop of water, insert a rubber gasket up and down, and do not use silica gel as a cushion. The fixing screw should not be tightened too tightly to avoid deformation of the cushion. The overflow hole should be aligned with the basin water hole.
3) Use rubber or plastic gaskets between the faucet and the basin to prevent hard contact and damage the basin.
4) The three-dimensional washbasin must be installed.
5) Fix the column and the bowl is fixed with a galvanized bolt 6 mm in diameter and a 1.5 mm thick rubber mat.
6) The pillar and the floor, the floor and the floor, the basin and the wall are connected by high quality mold sealant.
7) It is forbidden to use plastic hoses between the short-falling water and the drainage system, and the water-bearing bend should be installed. The joints must be sealed to prevent sewage from overflowing when plugged.
8) The fixing between the pot body and the wall should not use expansion bolts and apply Y-type nylon tube.
9) After the installation is completed, the water test is conducted for 2 hours to observe if any overflow occurs.
10) The top and bottom basins must be evenly sealed with high quality mildew sealant around the installation.

Bathroom Bathroom Waterproof Bathroom Washbasin