Sanitary ware installation process and attention points

Bathroom ware is one of the most frequently used household products in our daily life. Its installation affects the later use. Improper installation will not only cause health hazards, but also bring many economic hidden dangers, so what should be paid attention to when installing sanitary ware? Let's learn from us.

Sanitary ware installation process

Toilet process

Check the ground drain pipe → align the nozzle → level the alignment → draw the mark → punch the hole → apply the putty → set the rubber pad → screw the nut, → mark the two holes on the back of the tank, → punch → Insert the bolt → 捻 → → Back to the tank to find the right direction → Screw on the nut → Install the back water tank elbow → Install the splayed door → Turn the maiden fork to the right → Insert the drift door and the splayed door → tighten the nut.

Washbasin process

Insert the expansion bolts → 捻 → → the tube rack is hung up → put the washbasin on the rack to find the level → water connection: washbasin → straighten → water connection.

Shower process

Cold and hot water nozzles are flattened with test tubes → measure the size of the short section → install on the nozzle → wash the copper inlet of the shower with lead oil, wrap → nut tighten → fix on the wall → upper copper tube is installed in the three-port → The wood screws are fixed to the wall.

Bidet process

The door cover and nut of the mixing switch and the hot and cold water door are leveled, → the water gate is installed → the nozzle core door is installed → the hot and cold water door outlet nut is tightened → the nut of the mixing switch is tightened → three water door covers are installed → the magnetic basin is installed

Washing basin installation and construction essentials:

(1) The washing basin product should be flat and non-destructive. The drain plug should have an overflow hole of not less than 8 mm in diameter.

(2) When the drain plug and the sink are connected, the overflow plug of the drain plug should be aligned with the overflow hole of the sink to ensure the smooth flow of the overflow. After the insert, the upper end of the drain plug should be lower than the bottom of the wash basin.

(3) The bracket fixing bolts can be galvanized bolts or galvanized metal expansion bolts of not less than 6mm (if the wall is porous brick, expansion bolts are strictly prohibited).

(4) After the washing basin is connected with the drain pipe, it should be firm and compact, and easy to disassemble. The joint should not be open. Silicone paste caulking is applied to the wash basin and wall contact.

Sanitary ware installation precautions

1. Do not damage the waterproof layer. If it has been damaged or has no waterproof layer, it must be waterproofed first and tested by water leakage for 12 hours.

2. The sanitary ware is fixed firmly and the pipe interface is tight.

3. Pay attention to the protection of finished products to prevent bumps and sanitary ware.