Weapons spring floor damp refused to wet

After the convulsions, the temperature was warmer, and the hot and humid air hits. At this time, it is easy to rain the water. The floor in the home always feels wet. The dampness of the floor will cause mildew and various problems will occur, directly affecting the use of the floor. The editors introduced in detail some of the techniques for preventing moisture on the floor. Let's understand it together.

First, the damp floor phenomenon

The dampness of the floor will be easy to mold and deform, and the wooden floor will easily get damp due to the sudden change of weather. Therefore, in the spring when the dampness is serious, the anti-warping of the floor is also a big problem, and many people have had wet spots such as mildew on the floor of their homes.

Second, the damp floor response measures

1, avoid sun exposure during the wet period

The sunny days that are surrounded by moisture for a long time and the occasional sunny days are almost ecstatic, but the floor may not like the sun. If the wooden floor is suddenly exposed to the sun after being exposed to moisture, it will easily fade and crack. Install light curtain curtains, pull the curtains out of the sun, cover part of the sun, to avoid the sun damaged floor.

2, the surface cover protective layer

When it is particularly wet, you can lay a layer of plastic film on the floor and stick the corners to prevent the moisture from contacting the floor and prevent the floor from getting damp. Spreading a relatively large carpet on the floor is also one of the effective methods to prevent moisture from invading the floor. Apart from absorbing some moisture, it can also decorate the home environment.

3, bleach wipe

If you find that the floor surface grows a small amount of mildew, you can use warm bleach to mix with water in a dilution ratio of 1:3. Use a soft cloth to wipe. Note that the bleach concentration should not be too high. Too high a concentration will destroy the waxing of the floor surface and cause the floor to be wiped off. If there is mildew in the interior of the floor, it is necessary to immediately remove the mildewed floor and replace it with a new floor to prevent the mold from infecting other intact floors, resulting in a large area of ​​mildew.

4, floor cyclic waxing protection

When the floor has just been laid for half a month or a month, it is necessary to wax it for the first time, and then wax it at intervals of two weeks or one month. When three or four times are performed, the moisture in the new floor can be basically removed. It can also avoid the invasion of the floor in wet weather in spring and summer. Regular waxing keeps the light bright, and the most important point of daily maintenance of the wooden floor is waxing. When wood floors are used for a period of time, they need to be waxed again. This will not only release moisture from the construction work, but also extend the service life of the floor. In addition, the floor should be waxed once a quarter to maintain the light and waterproof properties of the floor surface.

5, moisture measures to do enough

The waterproof and dampproof measures before laying the floor must be completed, and the space close to the kitchen and bathroom should pay more attention. Waterproof material should be painted evenly. If there is a gap, use cement to make up. Near the water pipe, apply a 30cm high waterproof material.

In addition to the waterproof material, a layer of waterproof paper can also be laid under the floor, with a baseboard near the wall.

6, place the activated carbon

Activated charcoal protects the floor from dampness and activated charcoal can keep the floor in a good humidity environment. Due to the dual effects of moisture absorption and moisturizing of activated carbon (two-way humidity adjustment), the floor can not be cracked during long-term use, and moisture will not be generated when the floor has moisture; in the rainy season, this effect is more pronounced.

7, move heavy objects from damage

When the floor is damp, if there is heavy pressure on the floor, pit holes will easily appear. Therefore, the furniture must be moved for a long time to avoid the deformation of the same position on the floor caused by heavy pressure for a long time; when moving the furniture, it is best to lay a layer of film or cardboard on the floor surface to prevent the furniture from moving. Scratch the floor surface during the process, affecting the appearance of the floor; the furniture can be covered with a cushion on the feet, which can protect the furniture and protect the floor, extending the service life of both parties.

Floor wood floor floor maintenance floor waxing solid wood floor how to care