Faucet installation lecture hall four people faucet installation method

The faucet is everywhere in life, it is a switch that controls the flow of water. The first thing to get up in the morning is to turn on the faucet and start washing. It can be said that the faucet has opened the beginning of our new day. There are all kinds of faucets on the market. Today, Xiaobian talks about the installation of faucets and teaches you how to install faucets.

Single hole basin faucet installation

When purchasing a single-handle basin faucet, you should pay attention to the diameter of the water outlet. Most of the market is now a rigid pipe, so you should pay attention to the height of the water inlet. The 35 working points from the basin are most suitable. When installing, be sure to choose a special angle valve, and the angle valve must be fixed with the hot and cold water pipe of the wall outlet. When you find a distance between the angle valve and the water pipe on the faucet, purchase a special extension tube to connect. Remember, don't use other water pipes to connect, because if the water pressure is too large, it will fall off easily and leak water, causing damage to you. If the inlet pipe is too long to exceed the outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, bend it to the position you need as needed. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to remove water, please don't forget to buy the small interface of the faucet (the faucet is shorted). Don't forget to flush the water pipes buried in the wall before you install it.

Installation of shower and bathtub faucet (wall)

When you have purchased a shower, bathtub, or wall faucet, you can choose the right height to bury the water pipe. The spacing between the hot and cold water pipes must be 15 cm. Before installation, you must not forget to rinse the water pipe to avoid excessive water quality and damage to the faucet.

Concealed shower, bath faucet: After purchasing the concealed faucet, the sluice spool should be pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be buried. The plastic protective cover of the valve plug should not be easily removed when it is buried, so as to prevent the cement and other chores from damaging the valve core when it is buried. In addition, when pre-burying the valve core, you should also pay attention to the up and down and left and right directions of the valve core to avoid the valve core being buried. When the wall mounted faucet is pre-buried into the water pipe, the size is deviated, and the adjustment can be used to adjust the position.

Thermostatic faucet installation

Before installing the thermostatic faucet, please check if the water pipe is left hot and cold right. Remember not to connect the hot and cold water pipes incorrectly, so as to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat.

Single hole kitchen faucet installation

The requirements are stable, because the kitchen faucet is used frequently, and it is moved and moved, so it is easy to loosen, so the lock nut must be tightened. At present, some faucets appear on the market for the screw to increase the nut fixing. This kind of stability is very good. If it can solve the problem of water removal, it will be a popular trend in the future.

Don't look at the faucet, but it can't be separated from all aspects of the home. The above is the installation knowledge of the faucet brought by Xiaobian, and the installation method of the four faucets. The faucet is installed in various places in the home, and I hope I can help you.