Stainless Steel Barbecue Grate Barbecue wire Grill Grate is made of high quality 304 stainless steel, never rusting and durable. BBQ Wire mesh does not have any coating or chemical ingredients, making food safer. BBQ Grate Mesh,stainless steel wire BBQ grate,BBQ Grill Metal Mesh,stainless steel BBQ grill grate Shenzhen Lanejoy Technology Co.,LTD , https://www.szstainlesssteelwiremesh.com
Multi-functional Grill Cooking Grid Grate: This wire mesh is mainly used for BBQ Grill Mat for outdoor cooking, it can also be used as a cooling and baking rack. Or you can develop other uses for it.
Screw pump removal steps: 1, the screw pump and the motor from the emptying medium (to prevent the motor, toxic medium wounding); 2, remove the screw pump discharge body (1); 3, remove the screw pump stator (4) Remove the rotor (5) and the intermediate shaft (7); 5, Remove the drive shaft (44) and the shaft seal; 6 Remove the screw pump bearings (39) (41), positioning sleeve 40), should be taken out from the bearing housing; 7, long-term without the screw pump, to be anti-rust treatment, the method is to use non-painted metal surface rust smear, including the shaft surface, packing housing cavity, and lubrication. Screw pump assembly, Precautions: 1, the screw pump parts should be carefully cleaned assembly, inspection, damaged parts should be replaced; 2, the correct installation of the shaft so that the shaft rotation flexibility, no jamming phenomenon. 3, the shaft seal installation: stuffing box (18) should be installed, the packing gland (16) should be placed in the shell installation window, so that the adjusting bolt can be adjusted easily; 4. The mechanical seal should be installed with care; Clean and coated with grease; 5, the drive shaft twenty thousand to the joint assembly, the seal should be checked for damage, fill the cavity grease; 6, when installing the stator, the rotor smear the rotor, the stator cavity surface , Is conducive to the stator installation; 7, the body pressed tight, the nut tightening should be uniform; 8, installation and assembly, the coupling installation deviation: △ Y ≤ 0.2mm, △ α ≤ 30 '.