Modern stone can be used not only for indoor and outdoor decoration, but also for wall decoration. Because of the weight of stone, how to carry it in the wall decoration process? What are the main processes installed? What should you pay attention to during the posting process? 1. Construction process of stone wall hanging stickers: Cleaning and finishing the base wall → pre-embedded iron parts → sheet inspection and repair → tying the steel mesh → material pre-laying number → fixing the stainless steel wire on the plate → plate installation → leveling straight square → temporary fixed plate, closing plate joint → grouting → Clean and maintain work. 2. Construction points of stone wall hanging stickers: 1) The base layer treatment is a key link to prevent empty drums and fall off after installation. Must have sufficient strength and stiffness. The surface should be flat and rough. The smooth substrate should be chiseled at a depth of 5-15 rnm with a spacing of about 30 mm. The surface of the mortar, dust, oil stains, applied wire brush clean, and rinsed with water. 2) The connection between the steel mesh of the fixed stone and the embedded parts must be firm and reliable. The joint between each stone and the steel mesh should not be less than 4, and the wire for pulling should have anti-rust performance. 3) Stones with lower or thinner strength should be attached with fiberglass mesh on the back. 4) Before the mortar is poured, the back side of the stone and the base surface should be wetted, and the joint of the stone material should be temporarily sealed with the joint filler material to avoid leakage. 5), the mortar should be used 1:2:5 cement mortar, layered for perfusion, the height of each layer should be 150-2Oomm, and not more than 1/3 of the height of the plate and the compaction, after the initial condensation Inject the upper cement mortar. In short, if the wall stone is stable in the subsequent decoration and the decorative effect is obvious, then it must be paved according to the above construction process and key points. The precision stone net suggests that you should choose a regular construction team. Paving, and you can also supervise the construction according to the construction points above. The most common applications that machine screws tend to be used for involve metal parts and panels needing to be fixed securely together. This is a daily requirement across all manner of industrial, manufacturing, construction, assembly, process, and production environments. Machine Screw,Countersunk Machine Screw,Self Tapping Machine Screws,Stainless Steel Machine Screws Taizhou Risco Stainless Steel Products Co.,Ltd , https://www.riscofastener.com
How do you use machine screws? Simply put, you use machine screws in much the same way as you would use any other type of screw or bolt.
Follow the below steps for guidance on using machine screws:
You use a machine screw by drilling or tapping it into a pre-drilled hole or nut, using either a manual or powered screwdriver
Power tools are frequently associated with the use of machine screws. This is because fasteners of this type are typically demanded in more heavy-duty or industrial-scale assembly and construction jobs
In the vast majority of scenarios, machine screws will be used with a nut and driven into a pre-drilled (tapped) hole. When using a nut with a machine screw, the nut will typically go behind the rearmost component or part being fastened
Machine screws are versatile and are often used to join two or more different parts or components. Sometimes, they are also chosen to hold down or sandwich gaskets and membranes, as well as being used on terminal strips and for making numerous other sorts of electrical connections
A handy alternative use for machine screws is to separate and secure parts or panels which need to be kept at a fixed distance from one another. This is achieved via a type of threaded coupling which allows two machine screws to be driven in from opposing directions. The separation distance you require between parts will dictate the length of the coupling inserted between the two fasteners