Led Cabinet Light,Under Cabinet Led Light,Usb Charge Led Cabinet Light,Round Led Cabinet Light Shenzhen You&My Electronic Technology Co., Ltd , https://www.ymledtrade.com
Stripping machine specific operation:
First, the adjustment of the gap between the inlet and outlet of the mechanical part.
1. Visually measure the outer diameter of the wire to be stripped and the gap between the inlet and outlet wheels. The gap between the inlet and outlet should be slightly smaller than the outer diameter of the wire.
2. The wires are sequentially passed through the inlet hole, the positioning frame, the inlet pressure roller, the positioning catheter, the blade, the blocking piece, and the outlet pressing wheel. Visually check whether the wires are in a straight line, whether it is at the center of the two blades. If there is bending, adjust the positioning frame and the positioning pipe so that the wires are in a straight line.
3. Pull the wire out of the line pressure roller, hold the line pressure roller with your right hand, pull the wire out with your left hand, and try the friction between the wire and the wire pressure roller. If the wire can be pulled out, adjust the wire adjustment wheel to the fine direction. Until the left hand feels that the wire is difficult to pull out, if the wire is too flat, adjust the wire adjustment wheel to the thick direction until it is difficult to pull out the wire by hand, but it is not suitable to press the wire too flat.
4. Use the same wire and the same method of operation to adjust the clearance of the outlet roller.
Second, the operation and parameter setting of the computer stripping machine panel.
1. Press the setting button: select the function letter to be operated, then set the flashing digital parameter behind the function word, use the left and right buttons to change the position of the parameter to be adjusted, and use the lifting button to change the parameter size.
2. The letters and functions that are represented. Http://
H: Working mode, H-1 time line; H-2 time short line; H-3 time stripping 1~10 pieces.
S: Stripping speed (1~6), 1 is the slowest; 6 is the fastest.
F: Quantitative (1~9999) How many roots need to be peeled off at a time.
C: Wire diameter (0.1~9.9), please refer to the wire diameter table.
O: Retracting the knife (0.1 to 99.9) means that the blade is peeled off after the knife has been cut and the blade is retracted to a certain position. The line below 1 mm2 is between 0.1 and 1.0, and the line of 1 mm2 or more is 1.0. Generally, the parameter of the thin line is small and the reverse is large. (maximum of 1.2)
A: Line tail (0.1 ~ 99.9) For more details, please see: http://